Project Build

This project started out like any other. I bought the car to save on gas while I drove it as a daily back and forth to work. Once I realized it was faster than the 2010 Mustang GT I traded in on it, I decided I wanted to explore the possibilities of what this platform could do. I had it tuned in the first week and it was on E30 at 1,500 miles. I added a Full Race Intercooler and a Wastegate Actuator shortly there after and kept it in this configuration until a rod let go at 115,000 miles. It made 377 horsepower and 455 pound-feet of torque. Now on to the build.

The goal is to have a 600+ horsepower car that will run in the 10s at the dragstrip and still be drivable. Engineered Motorsport Solutions is putting the car together in Rogersville, TN. You can see the EMS (Engineered Motorsport Solutions) Youtube channel here: EMS YouTube

Here are the details on my project below.

DYNO rESULTS

641 HORSEPOWER & 550 TORQUE

Engine

2.0 TS Ford Fusion block - Semi Closed Deck Assembled by Jessie Ringley @Engineeredmortorsportsolutions.com

Block
Pistons

Custom High Compression Mahle, spec'd by EMS

Rods

Callies H Beam

Crankshaft

Factory forged crank

Head

Stock with mild porting

Stock Head
Camshafts

Piper 285 cams

Head Gasket

Ford Focus RS

Hardware

ARP 625+ studs

Fueling

Stock pump. The XDI EVO 35 Direct Injection Pump could not be saved.

HPFP
AUX Fueling
Port Injection
Di Injectors

Stock

Driveline

Low Mileage Stock 6R80, 6RStager from True Motorsports

Trans
Converter
Driveshaft

Custom Aluminum Unit

Rear End

Stock 3:15 Ratio

Axles

Wheels

Stock 18" Wheels with 245/45-18 Firehawk Indy 500 Tires

Daily
Drag PAK

Interior

Stock

Head Unit
3-Way front stage

Tweeters - Hertz HT25 Mids - Fountek FR-88EX Midbass - Peerless SLS 6.5

Subwoofers

Rockford Fosgate P3 10" subs

Amplifiers

US Acoustics - USA4060, Tweeters and mids. Precision Power P600.2, Midbass Precision Power P1000.1, Subwoofers

Signal processor

Rockford Fosgate 360.3

miscellaneous

Cobb Accessport

Tuning Device
Tuner
Port Injection

Radium Engineering Port Injection kit with Split Second Controller